Satellite Dish Tuning

Satellite dish installation used to require more than one person and an entire afternoon. It involved backbreaking work of shoveling and highly technical skills of wiring. With the improvements in satellite dish technology, today installation has become so easy that many people can do it themselves. This article will briefly touch on how to tune your satellite dish, once you have it installed. First, make sure that there is nothing between your satellite dish and the sky it is pointing to. Tree branches, buildings, flags, can all obstruct the signal your satellite is trying to pull in. After you've determined there's nothing in the way, adjust the antennae of the satellite dish to the position that your manufacturer recommends. After you have the antennae positioned, you will want to adjust the elevation-look angle according

to your manufacturer's instructions and be sure that you have connected the antennae line to the receiver. The receiver for your satellite dish should be turned on and positioned on a beacon channel that will allow you to tune your antennae. Turn your satellite dish one degree to the east for three degrees and reverse to the opposite direction. When your satellite dish signal reader shows the highest signal level, tighten the antennae and keep repeating these steps until the antennae have been securely fitted. After you have the antenna securely fitted, ground the antennae and the satellite dish signal line. And that's it! All you need to do now is make a big bowl of popcorn.